A New Oil Lines Group, Filter Support Group, and Front Cover Fastener Group Are Now Used on Certain C175-20 Engines {1261, 1307} Caterpillar


`
A New Oil Lines Group, Filter Support Group, and Front Cover Fastener Group Are Now Used on Certain C175-20 Engines {1261, 1307} [M0123936]
LUBRICATION SYSTEM
FILTER GP-ENGINE OIL
A New Oil Lines Group, Filter Support Group, and Front Cover Fastener Group Are Now Used on Certain C175-20 Engines {1261, 1307}
Engine
C175-20 (S/N: TZ81-190; BXR1-2170)

Description Of Change: New oil lines with improved clamping points are used to reduce fretting & vibration.

Adaptable To:

------ WARNING! ------

Do not operate or work on this product unless you have read and understood the instruction and warnings in the relevant Operation and Maintenance Manuals and relevant service literature. Failure to follow the instructions or heed the warnings could result in injury or death. Proper care is your responsibility.


The following changes are adaptable to the products within the listed serial numbers, and are effective with all products after the listed serial numbers.

The new and former parts are listed in Table 1.

Table 1
Required Parts 
New Group Number  Part Name  Former Group Number(1) 
502-6082  Engine Oil Lines Gp  441-4537 
503-4058  Filter Support Group  369-7524 
548-4098  Front Cover Fastener Gp  335-8743 
(1) The former part number listed is for reference only and may differ.

Note: The new groups are now serviceable at the part level.

Information System:

336 Excavator Plate Locations and Film Locations
336 Excavator Sound Information and Vibration Information
320 GX and 323 GX Excavator Machine Systems Troubleshooting Sensor Signal (Analog, Passive) - Test
320 GX and 323 GX Excavator Systems Travel Motor - Test - Measurement of Case Drain Oil
320 GX and 323 GX Excavator Machine Systems Troubleshooting Relay - Test
320 GX and 323 GX Excavator Systems Relief Valve (Crossover) - Test and Adjust
320 GX and 323 GX Excavator Systems Pump Control (Main Hydraulic) - Main Pump Regulator
320 GX and 323 GX Excavator Systems Main Hydraulic Pump
A New Remanufactured Part is Now Available for Certain Cat Engines {1000, 7754}
Cab Avoidance Function may Not Activate When Equipped with Narrow Work Tool on Certain 313 and 315 Excavators {7490}
Payload Calibration When Equipped with Narrow Bucket/Work Tool May Fail on Certain 313 to 352 Excavators {6001, 6101, 6502, 7490, 7494, 7610, 7620}
320 GC & 323 GC Excavator Engine Starting
C9 Marine Engines and Marine Generator Sets Crankcase Breather
320 GC Excavator Fuel System Primary Filter (Water Separator) Element - Replace
C9 Marine Engines and Marine Generator Sets Engine Oil Pan
320 GX and 323 GX Excavators Air Conditioning and Heating Air Conditioning and Heating System
320 GX and 323 GX Excavators Air Conditioning and Heating Control Panel (Air Conditioner and Heater)
C9 Marine Engines and Marine Generator Sets Alternator and Regulator
320GX Hydraulic Excavator Engine Supplement Hood - Remove and Install
320GX Hydraulic Excavator Machine Systems Check Valve (Cooler Bypass) - Disassemble
320GX Hydraulic Excavator Machine Systems Check Valve (Cooler Bypass) - Assemble
320 GX and 323 GX Excavators Air Conditioning and Heating General Information
320 GX and 323 GX Excavator Machine Systems Troubleshooting Sensor Signal (PWM) - Test
320 GX and 323 GX Excavator Machine Systems Troubleshooting Sensor Supply - Test