3512B Petroleum Engine Plate Locations and Film Locations Caterpillar


Plate Locations and Film Locations
`
1.1. Serial Number Plate
2.1. Information Plate

AVSpare engines are identified with serial numbers, with performance specification numbers, and with arrangement numbers. In some of the cases, modification numbers are used. These numbers are shown on the Serial Number Plate and the Information Plate that are mounted on the engine.

AVSpare dealers need these numbers in order to determine the components that were included with the engine. This permits accurate identification of replacement part numbers.

Serial Number Plate



Illustration 1g00421064
(1) Location of the Serial Number Plate

The Serial Number Plate is on the left side of the cylinder block near the rear of the engine.



Illustration 2g00123229
Typical Serial Number Plate

The following information is stamped on the Serial Number Plate: engine serial number, model and arrangement number.

Information Plate



Illustration 3g00421060
(1) Location of the Information Plate

The Information Plate is on the left side top surface of the cylinder block in front of the front cylinder head.



Illustration 4g00102789
Typical Information Plate

The following information is stamped on the Information Plate: engine's maximum altitude, horsepower, high idle rpm, full load rpm, fuel settings and other information.

Information System:

C9 Urban Transit Bus Engine Water Temperature Regulator - Remove and Install
Authorized Classic Machine Models {1000, 7000}
345D, 349D and 349D2 Excavators and 345D MHPU, 349D MHPU and 349D2 MHPU Mobile Hydraulic Power Units Machine Electronic Control System MID 039 - CID 0096 - FMI 04
3508C, 3512C and 3516C Marine Engines Vibration Damper - Remove and Install
3500B and 3500C Auxiliary Engines, Generator Set Engines, and Generator Sets Refill Capacities and Recommendations
C9 Urban Transit Bus Engine Exhaust Manifold - Remove and Install
C0.5, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Glow Plugs - Test
3500B High Displacement Generator Set Engines Refill Capacities and Recommendations
C27 and C32 Engines Electrical System
C9 Urban Transit Bus Engine Unit Injector - Install
C9 Urban Transit Bus Engine Unit Injector - Remove
C9 Urban Transit Bus Engine Fuel Filter Base - Remove and Install
3512B Petroleum Engine Refill Capacities and Recommendations
C6.6 Marine Generator Set Aftercooler Condensate Drain Valve - Inspect/Clean
C11 and C15 Engines for Caterpillar Built Machines E360 Low Engine Oil Pressure
C9.3 Marine Auxiliary Engines Zinc Rods - Inspect/Replace
3512B Petroleum Engine Specifications
C32 Marine Auxiliary Engine Diagnostic Flash Code Retrieval
3508B, 3512B and 3516B Generator Set Engines Alternator - Remove and Install - Alternator and Mounting Group
3126B Engine for Caterpillar Built Machines Engine Oil Pan
120M, 12M, 140M, 160M, 140, 150 and 160 Motor Graders Articulated Hitch
Installation of a Jacket Water Heater on 3412 Generator Sets{1383}
C11 and C13 Engines for Caterpillar Built Machines E059 Low Engine Coolant Level Warning
C27 and C32 Industrial and Petroleum Engines E360 Low Engine Oil Pressure