3512B Petroleum Engine Specifications Caterpillar


Specifications
`

Table 1
3512B Engine Specifications    
Rated speed (rpm)     1500 to 1950    
Idle speed (rpm)     600 to 900    
Cylinders and arrangement     60 degree Vee 12    
Bore     170 mm (6.7 inch)    
Stroke    
190 mm (7.5 inch)    
Type     4 stroke cycle    
Aspiration     Turbocharged    
Displacement per cylinder    
4.3 L (263 cu in)    
Total displacement    
51.8 L (3158 cu in)    
Rotation (flywheel end)     Counterclockwise    
Fuel     See this Operation and Maintenance Manual, "Refill Capacities and Recommendations" (Maintenance Section).    
Method of starting     Electric starting motor    
Maximum allowable air inlet restriction    
6.2 kPa (25 inch of H2O)    

Information System:

C9.3 Marine Auxiliary Engines Zinc Rods - Inspect/Replace
C11 and C15 Engines for Caterpillar Built Machines E360 Low Engine Oil Pressure
C6.6 Marine Generator Set Aftercooler Condensate Drain Valve - Inspect/Clean
3512B Petroleum Engine Refill Capacities and Recommendations
3512B Petroleum Engine Plate Locations and Film Locations
C9 Urban Transit Bus Engine Water Temperature Regulator - Remove and Install
Authorized Classic Machine Models {1000, 7000}
345D, 349D and 349D2 Excavators and 345D MHPU, 349D MHPU and 349D2 MHPU Mobile Hydraulic Power Units Machine Electronic Control System MID 039 - CID 0096 - FMI 04
3508C, 3512C and 3516C Marine Engines Vibration Damper - Remove and Install
3500B and 3500C Auxiliary Engines, Generator Set Engines, and Generator Sets Refill Capacities and Recommendations
C9 Urban Transit Bus Engine Exhaust Manifold - Remove and Install
C0.5, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Glow Plugs - Test
C32 Marine Auxiliary Engine Diagnostic Flash Code Retrieval
3508B, 3512B and 3516B Generator Set Engines Alternator - Remove and Install - Alternator and Mounting Group
3126B Engine for Caterpillar Built Machines Engine Oil Pan
120M, 12M, 140M, 160M, 140, 150 and 160 Motor Graders Articulated Hitch
Installation of a Jacket Water Heater on 3412 Generator Sets{1383}
C11 and C13 Engines for Caterpillar Built Machines E059 Low Engine Coolant Level Warning
C27 and C32 Industrial and Petroleum Engines E360 Low Engine Oil Pressure
C27 and C32 Engines for Caterpillar Built Machines E361 High Engine Coolant Temperature
2005/04/18 An Improved Rear Gear Group is Available for Reverse Engine Rotation {1204, 1206}
C27 and C32 Industrial and Petroleum Engines E539 High Intake Manifold Air Temperature
3500B High Displacement Generator Set Engines Programmable System Parameters
3412E Petroleum Engine ECM/Personality Module - Test