Retrofit SCR Aftertreatment Catalyst (SCR) - Replace Caterpillar


Catalyst (SCR) - Replace
`



NOTICE

Ensure that all components are free of contaminants before installing. Contaminants may cause premature wear and reduced component service life.


Note: Disposition and Recycling - Common components of exhaust aftertreatment devices include, but are not limited to, cordierite, silicon carbide, iron zeolite, vanadium, platinum, and palladium. After the devices are used in an engine exhaust flow they can include some by-products that result from combustion. Follow applicable Federal, State, and local regulations when handling or discarding used aftertreatment devices.




    Illustration 1g03487497

    (1) Hatch

  1. Remove Catalyst (SCR) hatch cover (1) nuts, bolts, and washers.

  1. Remove hatch cover (1) from the reactor unit.

  1. Remove gasket assembly from the sealing surface of the hatch cover.

  1. Remove SCR catalyst assemblies, felt strips, and insulation. Insulation and felt should be discarded and replaced with new material during installation.

  1. Install the SCR catalyst into the reactor housing. Verify correct the position of the SCR catalysts, felt strips and insulation.

  1. Replace all inner backing strip gaskets on the SCR catalyst cover.

  1. Install SCR cover assembly.

  1. Replace all bolts.

  1. Apply final torque to all bolts in a circular pattern. Refer to Specifications, SENR3130, "Torque Specifications" for the proper torque.

  1. Verify that all bolts are at the proper torque value.

Information System:

C18 Petroleum Engine Monitoring System
C18 Petroleum Engine Gauges and Indicators
14L Motor Grader Machine Systems Centershift Lock Bar and Bushings - Remove
C18 Petroleum Engine Product Description
14L Motor Grader Machine Systems Centershift Lock Bar and Bushings - Install
Bench Test Procedure for a CX31 On Highway Truck or AD22 Articulated Truck Transmission {3030, 3073}
Disassembly and Assembly Procedure for 3N-8891 Sea Water Heat Exchanger Gp {1379}
C18 Petroleum Engine Maintenance Interval Schedule
3512B and 3516B Generator Set Engines with Dynamic Gas Blending Air Inlet and Exhaust Lines
UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Electrical Connections
C13 and C15 Generator Sets Safety Messages
320D2 Excavator Machine Electronic Control System Diagnostic Capabilities
EMCP4.1/EMCP4.2 Integrated Voltage Regulator
Retrofit SCR Aftertreatment Exhaust Outlet Nitrogen Oxide Sensor - Inspect/Replace
12M Series 3, 140M Series 3, 160M Series 3, 140, 150 and and 160 Motor Graders Brake Control Valve (Service)
12M Series 3, 140M Series 3, 160M Series 3, 140, 150 and and 160 Motor Graders Brake Accumulator
Retrofit SCR Aftertreatment Catalyst (DOC) - Replace
Retrofit SCR Aftertreatment Diesel Particulate Filter - Replace
2013/11/21 New Engine Software is Now Used on Certain C32 Marine Engines {1901, 1920}
3512B and 3516B Generator Set Engines with Dynamic Gas Blending Air Inlet and Exhaust Lines
3512B and 3516B Generator Set Engines with Dynamic Gas Blending Air Inlet and Exhaust Lines
C4.4 Industrial Engine Coolant (Commercial Heavy-Duty) - Change
C4.4 and C7.1 Engines Fuel Rail Pressure Problem
C7 Petroleum Engine Product Description