C280-08 Marine Engine Plate Locations and Film Locations Caterpillar


Plate Locations and Film Locations
`
1.1. Engine Identification
2.1. Engine Information Plate
3.1. Serial Number Plate

Engine Identification

Cat engines are identified with serial numbers, with performance specification numbers, and with arrangement numbers. In some of the cases, modification numbers are used. These numbers are shown on the Serial Number Plate and the Information Plate that are mounted on the engine.

Cat dealers need these numbers in order to determine the components that were included with the engine. This information permits accurate identification of replacement part numbers.

Engine Information Plate



Illustration 1g02935657
(1) Engine information plate


Illustration 2g02935876

The engine information plate is located between the last two crankcase covers on the right-hand side of the engine.

Serial Number Plate



Illustration 3g02935658
(2) Engine serial number plate


Illustration 4g00123229

The serial number plate is located between the last two crankcase covers on the right-hand side of the engine.



Illustration 5g03527776
The serial number plated is located on top of the reactor housing.

Information System:

793F Tier IV Off-Highway Truck Field Assembly Wheel Chock - Install
793F Tier IV Off-Highway Truck Field Assembly Films - Install
C175 Oil Pressure Regulator Inspection and Rework{1304, 5117}
140, 150, 160, 12M Series 3, 140M Series 3 and 160M Series 3 Motor Graders Service Interval Chart
C11 and C13 Engines for Caterpillar Built Machines Valve Actuator (Variable) - Remove and Install
TA2 Technical Inspection for 3512B Dynamic Gas Blending Genset Engines{1000, 1050, 1250, 1300, 1350, 1400}
C15 and C18 On-Highway Engines Engine Oil Pan - Remove and Install
C13, C15, and C18 Tier 4 Final Engines Water in Fuel - Test
C15 and C18 On-Highway Engines Camshaft - Remove and Install
C15 and C18 On-Highway Engines Camshaft - Remove and Install
3516C Marine Engine Model View Illustrations
Procedure for Installing the 450-6188 Solenoid Valve Gp and 450-3897 Wiring Harness on G3500 Petroleum Engines{5479}
C15 and C18 On-Highway Engines Vibration Damper and Pulley - Remove and Install
C4.4 Engines for Caterpillar Built Machines Connecting Rod - For Use With Spheroidal Graphite Iron (SGI) Crankshaft
C15 and C18 On-Highway Engines Front Cover - Remove and Install
12M Series 3, 140M Series 3, 160M Series 3, 140, 150 and and 160 Motor Graders Centershift Lock
C11 and C13 On-Highway Engines Compression Brake Lash - Adjust
Exhaust Balance Valve Causing Regeneration Issues On Certain Tier 4i C13 Engines{1061, 5479}
C280-16 Engine Prelubrication Oil Pump - Remove and Install
C280-16 Engine Air Starting Motor - Remove and Install
C15 and C18 On-Highway Engines Valve Mechanism Cover Base - Remove and Install
C4.4 Industrial Engine Fuel Related Components in Cold Weather
C4.4 Engines for Caterpillar Built Machines Connecting Rod - Inspect
C4.4 Engines for Caterpillar Built Machines Glossary of Electronic Control Terms