3126B Engine for Caterpillar Built Machines Engine Oil Pan Caterpillar


Engine Oil Pan
`
3126B Engine for Caterpillar Built Machines [SENR9579]


Illustration 1g02969856
Left side view of engine

Table 1
Specification for 176-9429 Oil Pan Gp 
Item  Qty  Part  Specification Description 
Apply 3 to 5 mm (0.1 to 0.2 inch) of ultra black Loctite 598 to areas that are marked (1) on the sealing surface of the oil pan. The areas at the corners of the oil pan in the following locations:
1. Connecting joint of the front housing (2) and the front of the cylinder block.
2. Connecting joint of the flywheel housing (3) and the rear of the cylinder block. 
The sealing surfaces of the oil pan shall be free of oil, debris, gasket material, or any other sealant. The oil pan must be assembled and tightened to the cylinder block within 10 minutes of applying sealant.
213-0677 Liquid Level Switch  Torque to 120 ± 10 N·m (89 ± 7 lb ft)
203-3027 Valve As  Apply torque to the body. Do not apply torque to the nut (6).
Torque to 70 ± 7 N·m (52 ± 5 lb ft)

Information System:

3508B, 3512B and 3516B Generator Set Engines Alternator - Remove and Install - Alternator and Mounting Group
C32 Marine Auxiliary Engine Diagnostic Flash Code Retrieval
3512B Petroleum Engine Specifications
C9.3 Marine Auxiliary Engines Zinc Rods - Inspect/Replace
C11 and C15 Engines for Caterpillar Built Machines E360 Low Engine Oil Pressure
C6.6 Marine Generator Set Aftercooler Condensate Drain Valve - Inspect/Clean
3512B Petroleum Engine Refill Capacities and Recommendations
3512B Petroleum Engine Plate Locations and Film Locations
C9 Urban Transit Bus Engine Water Temperature Regulator - Remove and Install
Authorized Classic Machine Models {1000, 7000}
345D, 349D and 349D2 Excavators and 345D MHPU, 349D MHPU and 349D2 MHPU Mobile Hydraulic Power Units Machine Electronic Control System MID 039 - CID 0096 - FMI 04
3508C, 3512C and 3516C Marine Engines Vibration Damper - Remove and Install
120M, 12M, 140M, 160M, 140, 150 and 160 Motor Graders Articulated Hitch
Installation of a Jacket Water Heater on 3412 Generator Sets{1383}
C11 and C13 Engines for Caterpillar Built Machines E059 Low Engine Coolant Level Warning
C27 and C32 Industrial and Petroleum Engines E360 Low Engine Oil Pressure
C27 and C32 Engines for Caterpillar Built Machines E361 High Engine Coolant Temperature
2005/04/18 An Improved Rear Gear Group is Available for Reverse Engine Rotation {1204, 1206}
C27 and C32 Industrial and Petroleum Engines E539 High Intake Manifold Air Temperature
3500B High Displacement Generator Set Engines Programmable System Parameters
3412E Petroleum Engine ECM/Personality Module - Test
12M and 140 Motor Grader Shipping the Machine
3500 Petroleum Engines and Petroleum Generator Sets Specifications
C11 and C13 Engines Engine Oil Level Switch - If Equipped