C13, C15, and C18 Tier 4 Final Engines Valve Mechanism Cover Caterpillar


Valve Mechanism Cover
`


Illustration 1g06466398

Table 1
Item  Qty  Part  Specification Description 
8T-0100 Bolt  Tighten the bolts and studs to 18 ± 3 N·m (159 ± 27 lb in) in the numerical sequence as shown in Illustration 1. 
131-0353 Stud 
10  244-4500 Spring  Free length is 25 mm (1.0 inch)
5P-7970 Nut  Torque to 18 ± 3 N·m (159 ± 27 lb in)
227-4531 Engine Oil Filler Cap As  Tighten by hand until tight. 
582-6323 Breather As  Torque to 30.0 ± 7.5 N·m (265.5 ± 66.38 lb in), using assembly tool. 
574-1230 V-Band Clamp  Use the following procedure to tighten the clamp:
1. Loosen clamp nut and reorient the breather outlet, by hand.
2. Orient the breather clamp as shown in Illustration 1.
3. Tighten the clamp assembly to 8.5 ± 1.0 N·m (75.2 ± 8.9 lb in)

Information System:

C13, C15, and C18 Tier 4 Final Engines Turbocharger
12M Series 3, 140M Series 3, 160M Series 3, 140, 150 and and 160 Motor Graders Electronic Control (Power Train System)
G3600 A4 Engines Oil Pressure Is High
374F and 390F Excavators and 390F MHPU Mobile Hydraulic Power Unit Sensor Signal (PWM) - Test
C4.4 Engines for Caterpillar Built Machines Glossary of Electronic Control Terms
C4.4 Engines for Caterpillar Built Machines Connecting Rod - Inspect
C4.4 Industrial Engine Fuel Related Components in Cold Weather
C15 and C18 On-Highway Engines Valve Mechanism Cover Base - Remove and Install
C280-16 Engine Air Starting Motor - Remove and Install
C280-16 Engine Prelubrication Oil Pump - Remove and Install
Exhaust Balance Valve Causing Regeneration Issues On Certain Tier 4i C13 Engines{1061, 5479}
C11 and C13 On-Highway Engines Compression Brake Lash - Adjust
G3600 A4 Engines Exhaust Temperature Is High
16M Series 3, 16, 18M Series 3 and 18 Motor Grader Power Train System
G3600 A4 Engines Exhaust Temperature Is Low
C13, C15, and C18 Tier 4 Final Engines Exhaust Combustion (ARD)
G3600 A4 Engines Alternator Problem - Charging Problem and/or Noisy Operation
725C, 725C2, 730C, 730C2 and 730C, 730C2 EJECTOR Articulated Truck Systems Modulating Valve (Transmission Hydraulic Control)
New IGBT Driver For UPSB505 {1401, 4480}
G3600 A4 Engines Electrical Power Supply - Test
G3600 A4 Engines Fuel Temperature Is High
3516C Marine Engine Product Lifting
3500E Marine Engines Alarms and Shutoffs
2013/12/18 New Main Rotor, Bearing Sleeve, Bearing Retainer Bar, And Cable Lugs Are Now Available For Gas Generator Sets Packaged With 2650 Frame High Voltage Generators {4459, 5258}