C11 and C13 Engines Exhaust Manifold Caterpillar


Exhaust Manifold
`
C11 and C13 Engines [SENR9887]
AIR INLET AND EXHAUST SYSTEM
MANIFOLD GP-EXHAUST
C11 and C13 Engines Exhaust Manifold
C11 and C13 Engines Exhaust Manifold


Illustration 1g03540496


Illustration 2g03540523

Table 1
Specification for 391-4948 Exhaust Manifold Gp 
Item  Qty  Part  Specification Description 
12  116-3715 Taperlock Stud  Torque to 35 ± 5 N·m (26 ± 4 lb ft)
12  9X-6620 Locknut  Before assembly, apply Loctite C5A copper anti-seize to the threads and bearing surfaces.
Tighten the locknuts in the numerical sequence that is shown in Illustration 2. 
161-3398 Exhaust Manifold  Before assembly, apply a thin coat of 2P-2333 High Temperature Sealer to the outside diameter of the male end of the exhaust manifold. Remove excess high temperature sealer from the assembled joint. 
192-4697 Exhaust Manifold  Before assembly, apply a thin coat of 2P-2333 High Temperature Sealer to the outside diameter of the male end of the exhaust manifold. Remove excess high temperature sealer from the assembled joint.