Product Link E640 System Configuration File - Install Caterpillar


Configuration File - Install
`

Configuration files are already installed on all product that was built with a network manager in the factory. A configuration will need to be installed if one of the following have been performed.

  • Replaced a failed network manager

  • Retrofit kit installation

Configuration files can be found on SISweb by searching for the product serial number in the "Service Software Files" section of SISweb. If you are unsure of what configuration file you need for a retrofit installation, contact the DSN.

Complete the following steps to install the configuration file.

  1. Open WinFlash but do not flash any software. Refer to System Operation Troubleshooting Testing and Adjusting, UENR3697, "Electronic Control Module (ECM) - Flash Program" for more information.

  1. Once WinFlash is connected, open any web browser.



    Illustration 1g03715508



    Illustration 2g03516179

  1. Connect to the "Service Dashboard". Under the Product Link drop down, select "Config File Upload". Refer to Illustration 1 and Illustration 2.

    Note: Older versions of the PLE601 Network Manager Software, required the technician to type in the full URL of the "Config Upload" page. Flash the PLE601 Network Manager with the latest software, and load the configuration file through the "Service Dashboard" button.

  1. Choose the "Browse" button in order to upload the configuration file that is already stored on your computer.

  1. Select the "Upload" button in order to upload the configuration file.

    Note: The Network Manager will need to power cycle before the configuration file part number is displayed in the "Product Link Interface".

Information System:

Product Link E640 System ECM - Configure
14L Motor Grader Exhaust Elbow - Remove and Install
C175-16 Locomotive Engine Fuel Flow Is High
558 Forest Machine Machine Systems Pilot Valve (Joystick)
G3600 A4 Engines Data Link Configuration Status - Test
G3600 A4 Engines Data Link - Test
14L Motor Grader Diesel Exhaust Fluid Tank - Remove and Install
G3600 A4 Engines Detonation - Test
C4.4 and C7.1 Engines Sensor Signal (Analog, Active) - Test
XQP60 and XQP100 Rental Generator Sets Model View Illustrations
C280-08 Tier 4 Engine Temperature Sensor (DEF Manifold) - Remove and Install
G3600 A4 Engines Oil Temperature Is High
G3500H Generator Set Engine Valve Lash and Valve Bridge Adjustment
2013/11/13 A New Front Cover Used On Certain C11 and C13 Industrial Engines {1151, 1162, 1206}
C4.4 and C7.1 Engines Sensor Calibration Required - Test
14L Motor Grader Temperature Sensor (DPF Inlet, Flame Detect) - Remove and Install
Three60 Precision Control System Programmable Parameters
12M Series 3, 140M Series 3, 160M Series 3, 140, 150 and and 160 Motor Graders Location of Components (Steering System)
C15 and C18 On-Highway Engines Fuel Priming Pump - Remove and Install
3500 Petroleum Engines and Petroleum Generator Sets Gauges and Indicators
C15 and C18 On-Highway Engines Fuel Filter Base - Remove and Install - Secondary
C15 and C18 On-Highway Engines Fuel Transfer Pump - Remove and Install
C15 and C18 On-Highway Engines Fuel Pressure Regulator - Remove and Install
C15 and C18 On-Highway Engines Fuel Manifold (ARD) - Remove and Install