C11 and C13 Engines for Caterpillar Built Machines Fuel Filter Base - Remove and Install Caterpillar


Fuel Filter Base - Remove and Install
`
C11 and C13 Engines for Caterpillar Built Machines [RENR9214]
FUEL SYSTEM
FILTER GP-FUEL
C11 and C13 Engines for Caterpillar Built Machines Fuel Filter Base - Remove and Install
1.1. Removal Procedure
2.1. Installation Procedure

Removal Procedure


NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened component life.




    Illustration 1g01132492

  1. Disconnect harness assemblies (2) and (3).

  2. Disconnect hose assemblies (1) and (6).

  3. Remove bolts (4).

  4. Remove fuel filter base (5).

Installation Procedure


NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened component life.




    Illustration 2g01132492

  1. Position fuel filter base (5) on the engine.

  2. Install bolts (4).

  3. Connect hose assemblies (1) and (6).

  4. Connect harness assemblies (2) and (3).

Information System:

345 MHPUC Mobile Hydraulic Power Unit Hydraulic System Swing Motor - Test - Measurement of Case Drain Oil
307D, 311D, 312D, 313D, 315D, 318D, 319D, 320D, 323D, 324D, 325D, 326D, 328D, 329D, 330D, 336D, 340D, 345D, 349D, 374D, 390D and M325D Excavators Air Conditioning and Heating Control Panel (Air Conditioner and Heater)
C32 Marine Engines Coolant Level Sensor Circuit - Test
2005/03/07 Wireless Communication Adapter Allows Radio Frequency Communication Between Computer and Electronic Control Module {0785, 0788}
345C Excavator Hydraulic System Main Hydraulic Pump Air - Purge
C11 and C13 Engines for Caterpillar Built Machines Flywheel Housing - Remove and Install
C11 and C13 Engines for Caterpillar Built Machines Crankshaft Rear Seal - Install
307D, 311D, 312D, 313D, 315D, 318D, 319D, 320D, 323D, 324D, 325D, 326D, 328D, 329D, 330D, 336D, 340D, 345D, 349D, 374D, 390D and M325D Excavators Air Conditioning and Heating Troubleshooting Faults With Service Codes
C11 and C13 Engines for Caterpillar Built Machines Flywheel - Install
C11 and C13 Engines for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
C11 and C13 Engines for Caterpillar Built Machines Water Pump - Assemble
325D and 329D Excavators Machine Security System - If Equipped
3508B, 3512B and 3516B Generator Set Engines Accessory Drive (Front) - Remove - Engine Oil Pump and Water Pump
3508B, 3512B and 3516B Generator Set Engines Accessory Drive (Front) - Install - Engine Oil Pump and Water Pump
3508C, 3512C and 3516C Marine Engines Accessory Drive (Front) - Disassemble - Engine Oil Pump and Water Pump
3508C, 3512C and 3516C Marine Engines Accessory Drive (Front) - Assemble - Engine Oil Pump and Water Pump
C32 Marine Engines Digital Sensor Supply Circuit - Test
307D, 311D, 312D, 313D, 315D, 318D, 319D, 320D, 323D, 324D, 325D, 326D, 328D, 329D, 330D, 336D, 340D, 345D, 349D, 374D, 390D and M325D Excavators Air Conditioning and Heating Air Conditioning System Troubleshooting
C32 Marine Engines Electrical Power Supply Circuit - Test
C11 and C13 Engines for Caterpillar Built Machines Cylinder Head - Remove
C11 and C13 Engines for Caterpillar Built Machines Cylinder Head - Install
C11 and C13 Engines for Caterpillar Built Machines Camshaft - Remove
307D, 311D, 312D, 313D, 315D, 318D, 319D, 320D, 323D, 324D, 325D, 326D, 328D, 329D, 330D, 336D, 340D, 345D, 349D, 374D, 390D and M325D Excavators Air Conditioning and Heating Air Conditioning System Troubleshooting
C11 and C13 Engines for Caterpillar Built Machines Camshaft - Install