3508C, 3512C and 3516C Marine Engines Engine Oil Pump - Install Caterpillar


Engine Oil Pump - Install
`
1.1. Installation Procedure

Installation Procedure


NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened component life.




    Illustration 1g01142067

  1. Install the O-ring seal on adapter (11). Install the O-ring seal on elbow (7). Install the O-ring seal on engine oil pump (8). Apply clean engine oil to the O-ring seals.

  2. Lubricate the engine oil pump with clean engine oil. Before you install the engine oil pump, make sure that the shaft of the pump will turn by hand.

  3. Attach a suitable lifting device to engine oil pump (8). The weight of engine oil pump (8) is approximately 42 kg (93 lb). Align the splines of the engine oil pump with the splines of the drive for the engine oil pump. Position the engine oil pump on the front housing and install bolts (9).

  4. Install bolts (10). Install bolts (6).


    Illustration 2g01141965

  5. Position the gaskets and adapter (3). Install bolts (4), (5), and (2).

  6. Install tube assemblies (1) and the brackets.

  7. Fill the cooling system. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".

End By:

  1. Install the fuel transfer pump. Refer to Disassembly and Assembly, "Fuel Transfer Pump - Install".

Information System:

3508C, 3512C and 3516C Marine Engines Engine Oil Pump - Remove
C27 and C32 Generator Set Engines E360 Low Engine Oil Pressure
C27 and C32 Generator Set Engines E361 High Engine Coolant Temperature
C27 and C32 Generator Set Engines E194 High Exhaust Temperature
C15 and C18 Engines for Caterpillar Built Machines Diagnostic Codes
374F Excavator Bucket Linkage - Inspect/Adjust
3126B Engines Cooling System - Check - Overheating
3508B, 3512B and 3516B Generator Set Engines Exhaust Elbow - Remove and Install
3500 Engines Auxiliary Water Pump - Assemble
3500 Engines Auxiliary Water Pump - Disassemble
Reuse Guideline for Hydraulic Cylinder Position Sensor {5574, 5736}
3508C, 3512C and 3516C Marine Engines Auxiliary Water Pump - Remove
C0.5, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Fuel Quality - Test
C4.4 (Mech) Industrial Engine Cooling System - Test
C0.5, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Air in Fuel - Test
3508C, 3512C and 3516C Marine Engines Engine Oil Pump - Assemble
3508C, 3512C and 3516C Marine Engines Engine Oil Pump - Disassemble
C9 Engine For Caterpillar Built Machines Flywheel - Install
3500 Engines Engine Oil Pan - Assemble
3508C, 3512C and 3516C Marine Engines Engine Oil Pan - Disassemble
120M, 12M, 140M, 140, 150, 160M and 160 Motor Graders Transmission Power Flow
3500 Generator Sets Generator - Inspect
120M, 12M, 140M, 160M, 140, 150 and 160 Motor Graders Centershift Cylinder Mounting
C4.4 Generator Sets Product Lifting