14L Motor Grader Solenoid Valve (ARD Fuel) - Remove and Install - Pilot Caterpillar


Solenoid Valve (ARD Fuel) - Remove and Install - Pilot
`
1.1. Removal Procedure
2.1. Installation Procedure

Removal Procedure



    Illustration 1g03504339

  1. Remove panel (1).


    Illustration 2g03499491

  1. Cut cable strap (3). Disconnect harness assembly (2). Remove solenoid valve (4).


    Illustration 3g03515138

    Note: Cleanliness is an important factor. Before the disassembly procedure, clean the exterior of the component thoroughly. This action will help to prevent dirt from entering the internal mechanism.

  2. Remove nut (9), washer (8), and solenoid (7) from valve assembly (4).

  3. Remove cartridge assembly (6) and remove O-ring seals (5).

Installation Procedure

  1. Install solenoid valve (4) in the reverse order of removal.

    1. Tighten cartridge assembly (6) to a torque of 50 ± 5 N·m (37 ± 4 lb ft).

    2. Tighten nut (9) to a torque of 20 ± 2.5 N·m (177 ± 22 lb in).

Information System:

C7 and C9 Industrial Engines Exhaust Has Excessive Black Smoke
C8.7 and C12.9 Marine Engines Engine Vibration Is Excessive
C27 and C32 Engines for Caterpillar Built Machines Engine Overspeeds
C280-08 Tier 4 Engine Solenoid Valve (DEF Return) - Remove and Install
14L Motor Grader Solenoid Valve (ARD Fuel) - Remove and Install - Main
C280-08 Tier 4 Engine Pressure Sensor (Diesel Exhaust Fluid) - Remove and Install
2013/11/04 New Ferrite Bead and Relay Harness Is Now Available For Certain Generator Sets Equipped With PL421 {4450, 7606}
14L Motor Grader Clean Emissions Module - Remove and Install
C280-08 Tier 4 Engine Solenoid Valve (DEF Air) - Remove and Install
C280-08 Tier 4 Engine Regulator (DEF Air) - Remove and Install
2013/10/28 Engine ECM Clearing Process for Dealers Is Now Available on Certain Applications {1901, 1920}
14L Motor Grader Air Cleaner - Remove and Install
14L Motor Grader Temperature Sensor (Catalyst Inlet) - Remove and Install
C7 and C9 Industrial Engines Power Is Intermittently Low or Power Cutout Is Intermittent
14L Motor Grader Engine - Remove and Install
C4.4 Industrial Engine Engine Oil and Filter - Change
C280-08 Tier 4 Engine Pressure Sensor (DEF Air) - Remove and Install
G3600 A4 Engines System Overview
374F Excavator Machine Systems Overload Warning - Set - If Equipped
G3600 A4 Engines Electrical Connectors
G3600 A4 Engines Diagnostic Trouble Codes
C280-08 Tier 4 Engine Manifold (Diesel Exhaust Fluid) - Remove and Install
14L Motor Grader Nozzle Heater Harness - Remove and Install
14L Motor Grader Catalyst (SCR) - Remove and Install