14L Motor Grader Temperature Sensor (DPF Inlet, Flame Detect) - Remove and Install Caterpillar


Temperature Sensor (DPF Inlet, Flame Detect) - Remove and Install
`
1.1. Removal Procedure
2.1. Installation Procedure

Removal Procedure

Table 1
Required Tools 
Tool  Part Number  Part Description  Qty 
Loctite 771 Anti-Seize Compound 


    Illustration 1g03500336

  1. Remove panel (1).


    Illustration 2g03508501

  2. Disconnect temperature sensor (DPF inlet) (2).


    Illustration 3g03508503

  3. Disconnect temperature sensor (flame detect) (3).


    Illustration 4g03508504

  4. Remove cables straps (4).


    Illustration 5g03508506

  5. Remove cable strap (5).


    Illustration 6g03508559

  6. Remove cable strap (6).


    Illustration 7g03508596

  7. Remove cable straps (7).


    Illustration 8g03508597

  8. Remove cable straps (8) and temperature sensor (DPF inlet, flame detect) (9).

Installation Procedure

  1. Install temperature sensor (DPF inlet, flame detect) (9) in the reverse order of removal.

    1. Apply Tooling (A) to the threads on temperature sensor (flame detect) (3) and to the threads of temperature sensor (DPF inlet) (2). Tighten temperature sensor (flame detect) (3) and temperature sensor (DPF inlet) (2) to a torque of 45 ± 5 N·m (33 ± 4 lb ft).

Information System:

C4.4 and C7.1 Engines Sensor Calibration Required - Test
2013/11/13 A New Front Cover Used On Certain C11 and C13 Industrial Engines {1151, 1162, 1206}
G3500H Generator Set Engine Valve Lash and Valve Bridge Adjustment
Product Link E640 System Configuration File - Install
Product Link E640 System ECM - Configure
14L Motor Grader Exhaust Elbow - Remove and Install
C175-16 Locomotive Engine Fuel Flow Is High
558 Forest Machine Machine Systems Pilot Valve (Joystick)
G3600 A4 Engines Data Link Configuration Status - Test
G3600 A4 Engines Data Link - Test
14L Motor Grader Diesel Exhaust Fluid Tank - Remove and Install
G3600 A4 Engines Detonation - Test
Three60 Precision Control System Programmable Parameters
12M Series 3, 140M Series 3, 160M Series 3, 140, 150 and and 160 Motor Graders Location of Components (Steering System)
C15 and C18 On-Highway Engines Fuel Priming Pump - Remove and Install
3500 Petroleum Engines and Petroleum Generator Sets Gauges and Indicators
C15 and C18 On-Highway Engines Fuel Filter Base - Remove and Install - Secondary
C15 and C18 On-Highway Engines Fuel Transfer Pump - Remove and Install
C15 and C18 On-Highway Engines Fuel Pressure Regulator - Remove and Install
C15 and C18 On-Highway Engines Fuel Manifold (ARD) - Remove and Install
C15 and C18 On-Highway Engines Exhaust Cooler (NRS) - Remove and Install
C15 and C18 On-Highway Engines Electronic Unit Injector - Remove and Install
C15 and C18 On-Highway Engines Electronic Unit Injector Sleeve - Remove and Install
C15 and C18 On-Highway Engines Turbocharger - Remove and Install