C15 and C18 On-Highway Engines Flywheel - Remove and Install Caterpillar


Flywheel - Remove and Install
`
C15 and C18 On-Highway Engines [UENR3300]
BASIC ENGINE
FLYWHEEL GP
C15 and C18 On-Highway Engines Flywheel - Remove and Install
1.1. Removal Procedure
2.1. Installation Procedure

Removal Procedure

Table 1
Required Tools 
Tool  Part Number  Part Description  Qty 
FT2712  Guide Stud 


NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened component life.




    Illustration 1g03521506

  1. Remove two bolts (1). Install Tooling (A).

  2. Remove remaining bolts (1) that hold the flywheel to the crankshaft . Use two people and remove flywheel (2). The weight of flywheel (2) is approximately 35 kg (77 lb).


    Illustration 2g01953204
    Typical Example

  3. If necessary, use a hammer and a punch in order to remove ring gear (3) from the flywheel.

Installation Procedure

  1. Install flywheel (2) in the reverse order of removal.

  2. Lubricate bolts (1) with clean unused engine oil and tighten bolts (1) to a torque of 272 ± 27 N·m (201 ± 20 lb ft).

Information System:

CX31-P600 Petroleum Transmission Transmission Planetary Troubleshooting
C15 and C18 On-Highway Engines Water Temperature Regulator Housing - Remove and Install
CX31-P600 Petroleum Transmission Torque Converter Troubleshooting
CX31-P600 Petroleum Transmission Visual Inspection
2014/02/20 New Anti Drift Valves are Now Used on Certain 345D and 349D Excavators {5059}
C15 and C18 On-Highway Engines Engine Oil Pump - Remove and Install
Reuse and Salvage for Engine Dampers {1202, 1205}
G3500H Generator Set Engine Cooling System
C15 and C18 On-Highway Engines Engine Oil Filter Base - Remove and Install - C15
G3500H Generator Set Engine Lubrication System
C15 and C18 On-Highway Engines Engine Oil Filter Base - Remove and Install - C18
G3500H Generator Set Engine Air/Fuel Ratio Control - NO<SUB>X</SUB> Feedback
CX31-P600 Petroleum Transmission Hydraulic Oil Contamination - Test
C280 Marine Engines Battery
C15 and C18 On-Highway Engines Flywheel Housing - Remove and Install - Power Take Off equipped
C15 and C18 On-Highway Engines Power Take-Off Drive Group - Assemble
C15 and C18 On-Highway Engines Crankshaft Front Seal - Remove and Install
12M Series 3, 140M Series 3, 160M Series 3, 140, 150 and and 160 Motor Graders Hydraulic System
12M Series 3, 140M Series 3, 160M Series 3, 140, 150 and 160 Motor Graders Solenoid Valve - Test
C15 and C18 On-Highway Engines Rocker Arm and Shaft - Remove and Install
C15 and C18 On-Highway Engines Cylinder Head - Remove and Install
C280-16 Engine Exhaust Manifold Shield - Remove and Install
3516C Marine Engine Catalyst (SCR) - Replace
Procedure for Installing the 450-6188 Solenoid Valve Gp and 450-3897 Wiring Harness on G3500 Petroleum Engines{5479}