C15 and C18 On-Highway Engines Front Cover - Remove and Install Caterpillar


Front Cover - Remove and Install
`
1.1. Removal Procedure
2.1. Installation Procedure

Removal Procedure

Table 1
Required Tools 
Tool  Part Number  Part Description  Qty 
193-9199  Socket As 
−  Loctite 271  − 


NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened component life.




    Illustration 1g03529638

  1. Remove nuts (2) and bolts (1) and remove bracket and pulley assembly (3).


    Illustration 2g03529657

  2. Use Tooling (A) to remove button head screws (4).

  3. Remove nuts (7) and spacers (8) from studs (6).

  4. Remove front cover (5) from the front housing. Remove the seal from the front cover.

Installation Procedure

  1. Install front cover (5) in reverse order of removal.

    1. Tighten button head screws (2) to a torque of 21 ± 3 N·m (186 ± 27 lb in).

    2. Apply Tooling (B) to studs (4) prior to installation.

Information System:

C4.4 Engines for Caterpillar Built Machines Connecting Rod - For Use With Spheroidal Graphite Iron (SGI) Crankshaft
C15 and C18 On-Highway Engines Vibration Damper and Pulley - Remove and Install
C280-08 Marine Engine Plate Locations and Film Locations
793F Tier IV Off-Highway Truck Field Assembly Wheel Chock - Install
793F Tier IV Off-Highway Truck Field Assembly Films - Install
C175 Oil Pressure Regulator Inspection and Rework{1304, 5117}
140, 150, 160, 12M Series 3, 140M Series 3 and 160M Series 3 Motor Graders Service Interval Chart
C11 and C13 Engines for Caterpillar Built Machines Valve Actuator (Variable) - Remove and Install
TA2 Technical Inspection for 3512B Dynamic Gas Blending Genset Engines{1000, 1050, 1250, 1300, 1350, 1400}
C15 and C18 On-Highway Engines Engine Oil Pan - Remove and Install
C13, C15, and C18 Tier 4 Final Engines Water in Fuel - Test
C15 and C18 On-Highway Engines Camshaft - Remove and Install
12M Series 3, 140M Series 3, 160M Series 3, 140, 150 and and 160 Motor Graders Centershift Lock
C11 and C13 On-Highway Engines Compression Brake Lash - Adjust
Exhaust Balance Valve Causing Regeneration Issues On Certain Tier 4i C13 Engines{1061, 5479}
C280-16 Engine Prelubrication Oil Pump - Remove and Install
C280-16 Engine Air Starting Motor - Remove and Install
C15 and C18 On-Highway Engines Valve Mechanism Cover Base - Remove and Install
C4.4 Industrial Engine Fuel Related Components in Cold Weather
C4.4 Engines for Caterpillar Built Machines Connecting Rod - Inspect
C4.4 Engines for Caterpillar Built Machines Glossary of Electronic Control Terms
374F and 390F Excavators and 390F MHPU Mobile Hydraulic Power Unit Sensor Signal (PWM) - Test
G3600 A4 Engines Oil Pressure Is High
12M Series 3, 140M Series 3, 160M Series 3, 140, 150 and and 160 Motor Graders Electronic Control (Power Train System)